[AG-TECH] Interoperation between AG2 and AG3 venues

Andrew A Rowley Andrew.Rowley at manchester.ac.uk
Sat Dec 2 06:13:05 CST 2006


This should work so long as the multicast addresses and ports are the same for the same venue on both servers (we do this).  All venues must have statically assigned addresses as the servers do not communicate at all.

Andrew :)

Access Grid Support Centre,
RSS Group,
Manchester Computing,
Kilburn Building,
University of Manchester,
Oxford Road,
M13 9PL, 
Tel: +44(0)161-275 0685
Email: Andrew.Rowley at manchester.ac.uk 

> -----Original Message-----
> From: owner-ag-tech at mcs.anl.gov [mailto:owner-ag-tech at mcs.anl.gov] On
> Behalf Of Joseph Stone
> Sent: 01 December 2006 17:55
> To: 'ag-tech'
> Subject: [AG-TECH] Interoperation between AG2 and AG3 venues
> I've seen for some meetings (Town halls?) that AG2 users can see/hear AG3
> users.  How do I do this with our own venue?  I have tried configuring
> rooms
> with corresponding names on both venue servers to use the same multicast
> address (each has their own unicast bridge).  I was thinking that the
> multicast would act like a bus in this case.
> Thanks in advance,
> Joe
> Joseph Stone
> Senior Informatics Manager
> Family Medicine Community Health, Medical School, Univ. of Minnesota
> Suite 220 Dinnaken
> 925 Delaware St. SE
> Minneapolis, MN 55414
> (612) 624-3192
> stone004 at umn.edu

More information about the ag-tech mailing list