More Complete Audio Level Info
Lisa Childers
childers at mcs.anl.gov
Wed May 24 13:26:51 CDT 2000
Folks,
This is the latest:
First we level Net-Only
* Everyone starts out on net-only (preset 3)
- Those who don't have good net must sit out this round. Hang out on
telco-only (preset 2) and pay close attention to the mud
* Set rat Speaker Vol at 48
* Set rat Line-In Gain at 48
* Set ALL microphones to Coarse Gain 55dB, Gain 0dB
* Set "TX to Codec" at 0dB
* Set "To PA System" to 0dB
* Set "RX from Codec" to 0dB
All net-only nodes level audio now
Then we level Telco-Only
* go to preset 2
* Set "To PA System" gain to 0dB
* Set "From Telco Receive" gain to 0dB
* Set "To Telco Transmit" gain to 0dB
* Set ALL microphones to Coarse Gain 55dB, Gain 0dB
* Everyone dials into teleconference w/their gentner
All telco-only nodes level audio now
Then we take turns being the net<->telco bridge (preset 1)
* Only ONE node can be on preset 1 at any given time
* To switch net<->telco bridge from nodeA to nodeB:
- nodeB MUST have good net or it cannot be a Bridge node!
- nodeB agrees to be the bridge
- nodeA announces they are moving to net-only or telco-only
- nodeA moves to preset 2 or 3
- nodeB moves to preset 1
Bridge nodeB levels audio now
* ONLY BRIDGE NODE ADJUSTS GENTNER/RAT GAINS! All other nodes do not
change any settings
* There should be at least 2 net-only and 2 telco-only nodes on-grid to
debug the bridge
More information about the ag-tech
mailing list