[Nek5000-users] Interpolation between two meshes

[nek5000-users at lists.mcs.anl.gov]

Please update to the latest master. Note, g2gi was replaced by gfldr. 

Stefan

-----Original message-----
> From:nek5000-users at lists.mcs.anl.gov <nek5000-users at lists.mcs.anl.gov>
> Sent: Monday 27th March 2017 6:38
> To: Nek5000 <nek5000-users at lists.mcs.anl.gov>
> Subject: [Nek5000-users] Interpolation between two meshes
> 
> Dear Neks,
> 
> I have been using 'g2gi' to do interpolation between different meshes. Recently, I have noticed that when I interpolate between two big meshes (say 300000 elements in each mesh), the interpolation hangs at 'call findpts' and never moves on. I tried increasing
>  number of processors and changing 'lpart', but none of these worked.
> 
> I'm wondering what could cause the interpolation to hang at 'findpts'. Has anyone encountered similar issue?
> 
> Hope anyone could give me some advice. Thank you very much in advance.
> 
> Best regards,
> Tony
> _______________________________________________
> Nek5000-users mailing list
> Nek5000-users at lists.mcs.anl.gov
> https://lists.mcs.anl.gov/mailman/listinfo/nek5000-users