[petsc-dev] DMPlex + Cohesive Cells Setup

[Jacob Faibussowitsch]

Hello All,

What is the simplest possible configuration required to insert cohesive cells into a plex? Plex/tests/ex5.c would be the example to ape here but there is a lot there that I don’t (think) I need like a DS or any kind of physics. For now, I am essentially looking to:

1. Read the mesh
2. Perform some mesh analysis
3. Slap some cohesive cells along one/multiple areas identified in the previous step (maybe even everywhere?)
4. Save the new mesh

This doesn’t even have to parallel. 

Best regards,

Jacob Faibussowitsch
(Jacob Fai - booss - oh - vitch)
Cell: (312) 694-3391

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.mcs.anl.gov/pipermail/petsc-dev/attachments/20200831/ab244b5b/attachment.html>