[AG-USERS] Linux Docs
Mike Weaver
weaver at er.doe.gov
Thu Sep 15 10:19:34 CDT 2005
Check out Doug Kosovic's AG/Fedora site at
http://www.vislab.uq.edu.au/research/accessgrid/software/fedora/index.
html
You'll find the software (RPMs) and very detailed instructions. This
is a great resource and very well maintained. Thanks Doug, et. al.!!
Mike Weaver
US Department of Energy
-----Original Message-----
From: owner-ag-users at mcs.anl.gov [mailto:owner-ag-users at mcs.anl.gov]
On Behalf Of Jim Summers
Sent: Thursday, September 15, 2005 09:48
To: grid Access
Subject: [AG-USERS] Linux Docs
Hello List,
I have been asked to setup our Linux desktops so that they can become
access grid nodes.
I found the rpms for fedora 4 and was able to install them on my test
system. But from there I am pretty much at a loss as far as how to
proceed.
The documentation I have found so far seems to outline the steps
necessary for doing this on a windows system, but they do not apply to
the linux desktop.
I have poked around in the /usr/share/docs/AccessGrid directory and
found a INSTALL.Linux, but it only describes the steps to emerge it
onto
a gentoo system.
I also found a link to some docs for setting up an access grid room on
Linux but I did not think that was what I am after and the software
referenced did not match what I installed.
Are there any docs for getting a simple client node setup on Linux
using
the current versions of the software? If so, where might they be?
TIA
--
Jim Summers
School of Computer Science-University of Oklahoma
-------------------------------------------------
More information about the ag-users
mailing list