[AG-TECH] Bridge configurability

[Gurcharan S. Khanna]

hi,

we have an AG site in Kosovo at the American University of Kosovo,
and they only have a 12 Mbps connection to the outside. the mix of
H.261 and H.264 streams in the RIT venue is too much of a drain on
their capacity for a 24/7 load. also, no multicast, so they must use
a bridge.

is there any way to:

1) configure a bridge to distinguish between H.261 and H.264
to send one but not the other? or

2) apparently, if vic sends to a bridge, it also receives whether or
not you have a consumer service running. is there any way to send
a stream but have the bridge not send back any streams?

thanks,

-gurcharan

-- 
-------------------------
Gurcharan S. Khanna, Ph.D.
Director of Research Computing
Office of the Vice President for Research
http://rc.rit.edu

Assistant Research Professor, Ph.D. Program
Golisano College of Computing and Information Sciences
http://people.rit.edu/gskpop

Founding Director, Interactive Collaboration Environments Laboratory
Center for Advancing the Study of Cyberinfrastructure
http://icelab.rit.edu
---
Rochester Institute of Technology
IT Collaboratory Bldg. 17, Room 3119
Rochester, New York 14623-5603
Phone: 585-475-7504  ~  Cell: 585-451-8370
Email: gurcharan.khanna at rit.edu