[AG-TECH] h.264 vic

[gurcharan khanna]

hi,

i'm trying to set up the h.264 enabled vic in an AG node in Kosovo for a
large event tomorrow at RIT.

there are both audio and video problems but i will just try to fix the video
for now. when i enable the h.264 service as the only video service at all,
i get a thumbnail of not only the 264 stream but all the received streams
from the venue, even though i'm not running any consumer service. and
the bandwidth that goes along with it, muted or not. i'm bandwidth 
challenged
in Kosovo, and just want to run the 264 vic only.

why am i receiving video when i am not running a consumer service?

can i run the 264 vic standalone from the cmd line? where is it? or how
do i do that?

btw, i am using bridging and can send video ok into the bridge but cannot
receive any video back from the bridge. tried various bridges.

finally, rat shows signal in the listen window but headphones don't pick
up any audio. the windows xp system has built in MS RDP audio driver
but sometimes switches to SoundMax HD, but neither seem to allow
the headphones to connect to the signal RAT is obviously seeing. not
an AG issue but maybe someone can give me a clue.

mainly i need at least the 264 video w/o all the extra bandwidth of received
videos.

thanks for any insights,

-gurcharan


-- 
-------------------------
Gurcharan S. Khanna, Ph.D.
Director of Research Computing
Office of the Vice President for Research
http://rc.rit.edu

Director, Interactive Collaboration Environments Laboratory
Center for the Advancing the Study of Cyberinfrastructure
http://icelab.rit.edu
---
Rochester Institute of Technology
1 Lomb Memorial Drive
Rochester, New York 14623-5603
Phone: 585-475-7504  ~  Cell: 585-451-8370
Email: gurcharan.khanna at rit.edu
Http:  people.rit.edu/gskpop