[Nek5000-users] Parameters lx3, ly3 and lz3

nek5000-users at lists.mcs.anl.gov nek5000-users at lists.mcs.anl.gov
Fri Aug 14 13:55:42 CDT 2015


Dear Neks,

Does anyone have any clue on the lx3, ly3 and lz3 set-ups below?

Best,
Tony

________________________________________
Message: 3
Date: Wed, 12 Aug 2015 02:04:09 +0000
From: nek5000-users at lists.mcs.anl.gov
To: "nek5000-users at lists.mcs.anl.gov"
        <nek5000-users at lists.mcs.anl.gov>
Subject: [Nek5000-users] Parameters lx3, ly3 and lz3
Message-ID:
        <mailman.5516.1439345056.24727.nek5000-users at lists.mcs.anl.gov>
Content-Type: text/plain; charset="iso-8859-1"

Dear Neks,


I've got a quick question about the parameters lx3, ly3 and lz3. These are the parameters for mesh3, but I'm not sure how they work in the code. For velocity and pressure, I would assume we only use mesh1 and mesh2. I'm just wondering is it necessary to set lx3 to be equal to lx1 (if I'm using PnPn-2)? Or does it matter whether it is equal to lx1 or lx2?


Hope anyone could help with this. Thank you very much in advance.


Best regards,

Tony
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.mcs.anl.gov/pipermail/nek5000-users/attachments/20150812/00a6c4d1/attachment-0001.html>

------------------------------

_______________________________________________
Nek5000-users mailing list
Nek5000-users at lists.mcs.anl.gov
https://lists.mcs.anl.gov/mailman/listinfo/nek5000-users


End of Nek5000-users Digest, Vol 78, Issue 4
********************************************


More information about the Nek5000-users mailing list