[Nek5000-users] Non conforming mesh

[nek5000-users at lists.mcs.anl.gov]

Dear users and developers,
are non conforming elements currently supported by Nek5000?
I have built a rea file with pretex starting from a non conforming vtk mesh. Everything goes well until I try to run the solver, then I get the "Error in generalev" message.
Looking at the rea file, I found that the corresponding non conforming edges are marked with the 'J' and 'SP' labels, whose meaning is not reported at the wiki page:
http://nek5000.mcs.anl.gov/index.php/Boundary_Definition
Thank you in advance.
Best regards,
Giuseppe