<div dir="ltr">Goodmoring Neks,<div>I'm running some calculation on a laminar channel flow that contains a geometrical disturbance, similar to a "bump".</div><div>It has been proved experimentally that the flow upwind is not affected by the presence of this impingement.</div><div><br></div><div>Thus, in order to reduce the computational cost, I would like to <i>split</i> the case, say compute the "upwind" laminar channel flow separately, and then use the results as boundary conditions for a successive run, in my case containing the bump itself.</div><div><br></div><div>My question is: is it possible to extract the computed fields from a given plane, and then use them as an "inflow" boundary condition on a successive run?</div><div><div>I think I'll need to use the same mesh topology, in order to avoid any interpolation.</div></div><div><br></div><div><br></div><div>Thank you for your attention</div><div><br></div><div>Sincerely</div><div><br></div><div>Ciccio</div></div>