[Nek5000-users] Visit Grid Error Question

[nek5000-users at lists.mcs.anl.gov]

Hi All,

I'm using nek and Visit on a Linux platform, and Visit seems to work 
fine with my binary output files (param66 and param67 =4).  However, if 
I download all these files to a windows machine, and run visit on them, 
it gives me the error:

"VisIt could not read from the file "C:\temp\wind_base.nek5000".


The generated error message was:


There was an error opening C:\temp\wind_base.nek5000. It may be an 
invalid file. VisIt tried using the following file format readers to 
open the file: Nek5000


The following error(s) may be helpful in identifying the problem:

When attempting to use "Nek", the file matched the general format 
expected by the reader but eventually encountered this error: "The first 
time step in a Nek file must contain a mesh"."


File names are all the same, did binary ftp transfer, transferred all 
the files (.rea, .usr, etc...; except the obj directory) to make sure I 
wasn't missing something, and the mesh shows fine on the Linux machine.

Any ideas?


Thanks,
Murph


-- 

*Murphy Leo O'Dea, PE"Murph"*

PhD Student, Mechanical Engineering

/School Of Engineering And Computer Science/

/Oakland University/

mlodea at oakland.edu <mailto:mlodea at oakland.edu>

http://www.secs.oakland.edu/~mlodea/

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.mcs.anl.gov/pipermail/nek5000-users/attachments/20131124/746ddd9b/attachment-0002.html>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.mcs.anl.gov/pipermail/nek5000-users/attachments/20131124/746ddd9b/attachment-0003.html>