[Nek5000-users] Setting up a case from scratch

[nek5000-users at lists.mcs.anl.gov]

Hello
I want to setup a case of 2d cylinder in a channel. I plan to do this way

1. Make mesh in gmsh
2. Convert to vtx
3. Setup in prex and read vtx mesh.
3.1 make curved sides
3.2 set boundary conditions

I have already tried all these steps partly. I want to know if there is any
easier way to do it. Especially making curved sides and setting boundary
conditions needs to be done per boundary edge. Is there a way to make it
faster ?

Thanks
praveen
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.mcs.anl.gov/pipermail/nek5000-users/attachments/20121127/080f1506/attachment.html>