[Nek5000-users] [*] Re: Zero flux boundary conditions

[nek5000-users at lists.mcs.anl.gov]

Hi Frank,

     Thanks for that. I ran the code with "I" boundary condition and it 
produces the same result as with "SYM" boundary condition.

Regards,
Mani chandra
On 05/15/2010 12:21 PM, nek5000-users at lists.mcs.anl.gov wrote:
> Hello Mani,
>
> Use the "I" boundary condition to do this.
>
> Cheers,
> Frank
>
> On Sat, 2010-05-15 at 10:50 +0530, nek5000-users at lists.mcs.anl.gov
> wrote:
>    
>> Dear Nek devs,
>>
>>       How does one put in zero-flux boundary conditions for temperature?
>> The nek wiki says that anything other than the primitive boundary
>> conditions will be taken as zero-flux but in the benard example, the
>> "zero-flux" condition for velocity was put in using the SYM boundary
>> condition which is a primitive boundary condition as shown in the nek
>> wiki. Could you please clarify?
>>
>> Regards,
>> Mani chandra
>> _______________________________________________
>> Nek5000-users mailing list
>> Nek5000-users at lists.mcs.anl.gov
>> https://lists.mcs.anl.gov/mailman/listinfo/nek5000-users
>>