Hi,<br><br>I was trying to build moab but met with the "mbcn_test fail" during make check.<br>The commands I used to build the library were:<br><br>./configure LFLAGS=-static --with-mpi=/home/tiantian/ITL/mpich2-1.4.1p1/gcc --with-hdf5=/home/tiantian/hdf5 --with-netcdf=/home/tiantian/ITL/netcdf-4.1.3/gcc --with-zlib=/home/tiantian/ITL/zlib-1.2.5/gcc --with-szip=/home/tiantian/ITL/szip-2.1/gcc --prefix=/home/tiantian/ITL/moab 2>&1 | tee configure.log<br>
make 2>&1 | make.log<br>make check 2>&1 | tee make.check.log<br><br>Looks like the mbcn_test is about query on entities, I don't know why this went wrong. Later I ignored the make check errors and did "make install". I tried to perform parallel read/write and found mbconvert went wrong too:<br>
<br>$mpiexec -np 2 ./mbconvert -O PARALLEL=READ_PART -O PARTITION=MATERIAL_SET -O PARALLEL_RESOLVE_SHARED_ENTS -O PARALLEL_GHOSTS=3.0.1 -o PARALLEL=WRITE_PART ./64bricks_512hex.h5m dummy.h5m<br>Read "./64bricks_512hex.h5m"<br>
<br>=====================================================================================<br>= BAD TERMINATION OF ONE OF YOUR APPLICATION PROCESSES<br>= EXIT CODE: 139<br>= CLEANING UP REMAINING PROCESSES<br>= YOU CAN IGNORE THE BELOW CLEANUP MESSAGES<br>
=====================================================================================<br>APPLICATION TERMINATED WITH THE EXIT STRING: Segmentation fault (signal 11)<br><br>I suspect some fundamental functions in moab were not properly made?<br>
I had attached the log files. Please take a look.<br><br>Thanks a lot for your help!<br><br>Best,<br>Tiantian<br>