Hi,<br>
<br>
We have been using a Rav 600 for teleconferencing for a while, and must
say its quite good. However when I put it to use in the AG I am a
little at a loss in the amount of problems I'm encountering. It is
connected to phone jack as well as connected to the line in of the
sound card. We can still make very good conf. calls, and have adjusted
the sensitivity of the mics, echo cancelation, and input levels to suit
the room size and position of participants in a typical teleconf.
However, those settings don't seem to translate well to the AG. The
general problem I'm faced is which echo problems, despite the fact that
the mics are muted, the sound still travels to the sound card.<br>
<br>
So a couple of questions for any ClearOne Rav users out there:<br>
<br>
1. How did you setup your connection to the mixer? I'm currently using
the playback(sound card speaker out) and record(sound card line in) rca
connections<br>
2. What settings did you have to change? I don't use ALC to fine tune
the sensitivit of the MIC. I have AEC to automatically control the
echo. <br>
3. What is necessary on the soundcard settings? I'm using a builtin soundcard probably an AC'97 compliant under Windows XP<br>
4. What are your settings for RAT? I have mine set to Gain of 4,
anothing louder seems to pick up alot of background noise. Is there
anything else I can adjust in the RAT?<br>
<br>
Thank you in advance.<br>
<br>
Proshanta<br>