[AG-TECH] Somewhat there with the AP400

[Jason Bell]

Jeremy

I recently assistance an colleague with "reconfiguring" an AP from scratch.  I remember this was a little trickly in finding.  I don't have any AP's anymore, so if you could send me some screen shots from the APware software (particularly the output and matrix screens) and I should be able to remember how to do it from there.

Cheers,
Jason.



-----Original Message-----
From: ag-tech-bounces at lists.mcs.anl.gov [mailto:ag-tech-bounces at lists.mcs.anl.gov] On Behalf Of Jeremy Mann
Sent: Saturday, 9 April 2011 03:20 AM
To: ag-tech
Subject: [AG-TECH] Somewhat there with the AP400

I managed to get an old enough laptop to load the APware software on and I am so close to getting this right. I configured it exactly like the documents say, however it is for using a powered amp on Output 1.
I want to use the built in amp on the AP400. Which output setting do I select to use this speaker?

--
Jeremy Mann
jeremy at biochem.uthscsa.edu

University of Texas Health Science Center Bioinformatics Core Facility http://www.bioinformatics.uthscsa.edu
Phone: (210) 767-3419